Iron Remover X - User Guide
-
Rinse car fully.
-
Apply a light coating of Iron Remover X to the exterior of the vehicle (stronger results come with a pressurized sprayer).
-
Allow the product to settle and notice it turning purple (this is the contaminants being eaten off the surface).
-
Hose the car and watch as the water takes the previously-embedded metal contaminants away.
-
End with a polish, seal, wax, or however you normally get the right finish.
Warning
Don’t leave the product sitting for too long on the car’s surface and be careful with direct sunlight. Avoid contact with eyes and always apply Iron Remover X carefully. Keep from the reach of children. Ensure that all Iron Remover X has been removed with the final rinse.
Information
Iron Remover X doesn’t fully replace a clay bar or mitt. Instead, the two should be used in conjunction with one another for best results; Iron Remover X alone will remove between 85% and 90% of metallic contaminants.
The closer you are to industrial activity, whether a factory or perhaps under a flight path (close to an airport), the more frequently you’ll need to apply. Otherwise, this is a quarterly or biannual event.
When metallic contaminants stick to the finish, it can affect appearance. It then gets wet and has the potential to cause rust. By working Iron Remover X into your treatment schedule, you limit damage and keep the vehicle sparkling.